Select Page

RUT240 Graphs

Summary #

The Graphs page contains various graphs that display statistical data changes in real time.

The information on this page has been updated in accordance with the RUT2XX_R_00.01.12.x firmware version.

Mobile Signal #

The Mobile tab graph displays mobile signal strength (RSSI, measured in dBm) value changes over a period of three minutes in one second intervals. The image below is an example of the Mobile Signal Strength graph.

Load #

The Load tab displays a tri-graph that illustrates average CPU load values in real time. The graph consists of three color coded graphs, each one corresponding to the average CPU load over 1 minute (red), 5 minutes (orange) and 15 minutes (yellow). The image below is an example of the Realtime Load graph.

Traffic #

The Traffic tab provides users with the possibility to monitor average inbound and outbound traffic over the course of 3 minutes at 3 second intervals. The Realtime Traffic Bridge graph consists of two color coded graphs: the green graph shows the outbound traffic, the blue graph shows the inbound traffic. Although not graphed, the page also displays peak loads and averages of inbound and outbound traffic. The image below is an example of the Realtime Traffic Bridge graph.

The following table provides a brief description of each of the Realtime Traffic graphs.

GRAPHDESCRIPTION
BridgeCumulative graph, which encompasses wired Ethernet LAN and the wireless network
LANDisplays traffic that passes through the LAN network interface(s) in graph form
WAN (Wired)Displays traffic that passes through the Wired WAN connection in graph form
HotSpotDisplays traffic that passes through the HotSpot interface in graph form
WiFiDisplays traffic that passes through the WiFi interface in graph form
MobileDisplays traffic that passes through the Mobile interface in graph form

Wireless #

The Wireless tab displays the Realtime Wireless graphs over three minutes in three second intervals. The first graph displays signal strength, signal noise, average and peak signal levels and the theoretical maximum channel permeability. The second graph displays the Phy Rate for the wireless connection. The images below are examples of both Wireless graphs.

Connections #

The Connections tab displays the Realtime Connections graph which shows currently active network connections with the information about network, protocol, source and destination addresses and transfer speed. The table below the graph displays basic information on active connections. The images below are examples of both of the Realtime Connections graph and the corresponding table.

Submit a Comment

Your email address will not be published. Required fields are marked *